
ENERPRO - EPW series
Standard Features
- 6 DHW Heater models available with inputs ranging from 1000 to 4200 MBtu/hr.
- All welded water tube design heat exchanger, 316L headers, 316TI condensing tubes, counter flow, horizontal cylindrical construction
- Up to 99% Thermal Efficiency
- Maximum allowable working pressure MAWP of 160 psig
- Maximum allowable discharge temperature of 210°F
- Return water temperatures as low as 40°F
- Suitable for Category II and Category IV installations
- Single point input adjustment for control of air and gas
- Low noise level
- Low gas pressure switch
- High Gas pressure switch
- Low water cut off (manual reset)
- High temperature (Manual reset)
- Inlet regulator for incoming gas pressures up to 2” PSIG.
- Forced draft burner
- Easy access to components for maximum serviceability
- For operation with natural gas or propane
- Flame failure alarm contacts
- 5:1 turndown ratio with a minimum 20% firing rate
- Suitable for venting with AL29-4C vent material
- Pure white finish outer jacket
- Operation through the 4-20mA or 0-10Vdc for set point or fire rate control
Optional Features
- Local/Remote switch for building management, remote modulation and set-point control
- Low water cut off (automatic reset)
- Gateway protocol converter for BACnet, Metasys N2, IP or LonWorks
- Neutralization kit for condensate water
- Remote operation for set-point or fire-rate control utilizing 0-10VDC
- DHW sensor with well
CONSULT FACTORY